6.5 Connections of one or more
video cables
CDS installation type (Cable Distribution
System). The installation is type TNV-1, do
not connect it to SELV circuits.
6.5.1 Connecting the main video
The video signal is present on connectors J5 and J7 of
the board. Only use one connector.
Connector J5: Connect the screen and the central
cable to terminals GND and CVBS respectively.
Connector J7: Connect the coaxial cable to the BNC
connector (not supplied) and then connect it to
connector J7.
The terminals accept cables with sections between
1.5mm² (16 AWG) and 0,5mm² (30 AWG).
J7
Fig. 12
16
J5
6.5.2 Connecting the secondary video
Connect the coaxial cable to the BNC connector (not
supplied) and then connect it to connector CN3.
CN3
Fig. 13
6.5.3 Video signals output (models with
double camera)
Video outputs description:
• Main video: The output is used to transmit the
video signal of the integrated module (connectors
J5, J7).
• Secondary video: The output is used to transmit
the video signal of the thermal module (connector
CN3)
6.5.4 Video signal output (only for
models with thermal camera)
Video outputs description:
• Main video: In all models fitted with thermal
camera only, the main video output is used for the
transmission of the thermal camera video signal
(connectors J5, J7).
• Secondary video: The secondary video signal is
not used (connector CN3)
MNVCUCT_1511_EN