Videotec Ulisse Compact Manuel D'instructions page 59

During start-up the pan & tilt is
PROBLEM
disabled and the following type
of message is shown:
Address : 1
DE-ICE PROCEDURE
IN PROGRESS...
REMAINING MINUTES:59
MNVCUCT_1511_EN
The environment temperature is
CAUSE
too low.
SOLUTION Wait until the end of the pre-heating
procedure. If the air temperature is
too low the unit will remain disabled
and the following message will be
shown:
Address : 1
DE-ICE PROCEDURE
------------------------
SYSTEM BLOCKED
TEMPERATURE TOO LOW
------------------------
Error E1-AUTOPAN WITHOUT
PROBLEM
LIMITS.
The two presets used as limits have
CAUSE
not been programmed.
SOLUTION Program the two presets and then
update the Autopan configuration
menu (10.2 Saving a Preset, page 49
e 8.1.10.7 Autopan Menu, page 37).
57