Technical Data; General; Mechanical; Electrical - Videotec Ulisse Compact Manuel D'instructions

15 Technical data

CAUTION! TNV-1 installation type. The
installation is type TNV-1, do not connect it
to SELV circuits.
CAUTION! In order to reduce the risk of fire,
only use UL Listed or CSA certified cables
sizes greater than or equal to 0.13mm² (26
AWG).

15.1 General

Constructed from aluminium and tecnopolymer
Epoxypolyester powder painting, RAL9002 colour
Germanium window for thermal camera
Easy installation thanks to the self-centring connector
Zero backlash
Quick configuration and setup
Dynamic positioning control system
16-characters string for zone and preset titling
Functions: Autopan, Preset, Patrol, Tour (maximum 3),
Autoflip

15.2 Mechanical

Cable glands: 2xM16, 2xM12
Horizontal rotation: continuous
Vertical rotation: -90° to +90°
Horizontal speed (variable): from 0.1° up to 200°/s
Tilt speed (variable): from 0.1° up to 200°/s
Preset accuracy: 0.05°
Unit weight: 12.5kg (28lb)
MNVCUCT_1511_EN

15.3 Electrical

Power supply/Current consumption:
• 230Vac, 0.4A, 50/60Hz
• 24Vac, 4A, 50/60Hz
• 120Vac, 0.8A, 50/60Hz
Power consumption
• 40W: P&T stopped, heating switched off
• 60W: P&T in motion, heating switched off
• 125W: peak at start-up, heating switched on
Input cables size: AWG 16-AWG 19
Dimensions of signal cables: AWG 16-AWG 30
Video line: coaxial cable (1Vpp, 75Ohm)
I/O alarm card
• Alarm inputs: 6
• Relay outputs: 2 (2A, 30Vac/60Vdc max)

15.4 Communications

Configuration through OSD
Half-duplex serial RS485 interface, full-duplex RS422
and daisy-chain architecture
Firmware updating from console in remote mode
(only VIDEOTEC MACRO and PELCO D protocols)
Up to 1023 units, addressable by means of dip-
switches

15.5 Protocols

AMERICAN DYNAMICS, ERNITEC, PANASONIC, PELCO
D, VIDEOTEC MACRO
Maximum number of presets for protocol
• AMERICAN DYNAMICS: 95*
• ERNITEC: 250
• PANASONIC: 250
• PELCO D: 99*
• VIDEOTEC MACRO: 250
*250, from OSD only (On Screen Display)
59