SWM RS 300 R 2016 Manuel - Utilisation - Entretien page 120

FLUID CHANGE
The brake fluid should be checked and changed in
accordance with the Periodic Maintenance Chart
or whenever it is contaminated with dirt or water.
Don't change the fluid in the rain or when a strong
wind is blowing.
CAUTION*:
* Use only brake fluid from a sealed contain-
er (DOT 4). Never use old brake fluid.
* Never allow contaminants (dirt, water,
etc.) to enter the brake fluid reservoir.
* Don't leave the reservoir cap off any
length of time to avoid moisture contami-
nation of the fluid.
* Handle brake fluid with care because it
can damage paint.
* Don't mix two types of fluid for use in the
brake. This lowers the brake fluid boiling
point and could cause the brake to be inef-
fective. It may also cause the rubber brake
part to deteriorate.
EN - 50
To replace the fluid, proceed as follows:
- Remove the rubber cap on the bleeding valve (1)
or (1A).
- Attach a clear plastic hose to the bleeding valve
on the brake caliper and turn the other end of
the hose into a container.
- Remove fluid reservoir cap (2)or (2A: 21 mm
wrench) and the rubber.
- Loosen bleeding valve on the brake caliper.
SM
RS
1A
RS
2
SM
2
1
1
2A