Cot Fastener Installation; Floor Plate Mounting Model; Floor Plate Installation - Stryker Power-PRO TL 6385 Manuel D'utilisation Et D'entretien

English

FLOOR PLATE MOUNTING MODEL

The Stryker Cot Fastener System for the Floor Plate Mounting Model is designed to be compatible only with cots which
conform to the Floor Plate Mounting Installation specifications listed below and comply with section 3.11.5 and 3.11.7
of the Federal Specification for the Star-of-Life Ambulance, KKK-A-1822 Revision E.

FLOOR PLATE INSTALLATION

1. Determine the desired position of the cot inside the vehicle allowing for proper clearance around the cot.
Note: Federal ambulance specifications regarding aisle width and attendant seating may affect positioning of
the mounting brackets. If specifications do not apply, the installer should be certain there is adequate clearance
for proper patient access, traction splint projection, rear door closure, etc.
2. Using the dimensions shown in Figure 1, locate and drill the points where the floor plates will attach.
Return To Table of Contents
1-10

Cot Fastener Installation

Figure 1: Floor Plate Installation Locations
6385-009-005 REV B www.stryker.com