Ribimex Ribiland PR4EN1T/2 Manuel D'instructions Et D'utilisation page 64

Outils multifonctions 4 en 1 thermique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fig.HT9
Horizontal cut: cutting close to ground from
standing position (e.g. low shrubs)
Fig.HT11
Vertical cut: cutting without standing directly
next to hedge (e.g. flowerbed between operator
and hedge)
VI. MAINTENANCE
6.1- Daily maintenance
Always wear gloves when working around the cutter assembly.
WARNING!
1. Clean any debris or dirt from the hedge trimmer cutter blades.
Lubricate the blades before use and after refueling.
Check the cutters for damage or incorrect adjustment.
2. Check for loose or missing screws or components.
Make sure the cutter attachment is securely fastened.
3. Check the entire machine for leaking fuel or grease.
4. Make sure the nuts, bolts, and screws (except carburetor adjusting screws) are tight.
Before performing any maintenance, repair, or cleaning work on the unit, make sure the
WARNING!
engine and cutting attachment are completely stopped. Disconnect the spark plug wire
before performing service or maintenance work.
! Non-standard parts may not operate properly with your unit and may cause damages
WARNING
and lead to personal injury.
6.2- 10/15-hour maintenance
Lubricate the cutter assembly gearbox by pumping one or two strokes of lithium-base grease into
the grease fitting using a lever-type grease gun. See Fig.HT13
! Over-lubricating can cause the gearcase to operate sluggishly and can cause grease to
CAUTION
leak out.
Fig.HT10
Horizontal cut: cutting without standing directly
in front of the hedge (e.g. reaching over a
flowerbed)
Fig.HT12
Overhead cut: hold the shaft upright with a 90 °
blade angle to cut upper surface of hedge.
Page 64 / 99

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ribiland f43-a

Table des Matières