Ribimex Ribiland PR4EN1T/2 Manuel D'instructions Et D'utilisation page 61

3.1- Safety Operation
An articulated hedge trimmer has the potential to do serious damage if misused, abused or
mishandled. To reduce the risk of injury, you must maintain control at all times, and observe all
safety precautions during operation. Never permit a person without training or instruction to
operate this machine!
This machine is designed especially for trimming hedges
Never use this machine for any other purposes. Never try to cut stones, metals, plastics or any other
hard objects.
Using for other purposes than trimming hedges may damage the machine or cause serious injury.
Always wear eye and ear protection. Manufacturer recommends wearing a face shield as additional
face and eye protection. Secure long hair above shoulder level.
Always wear a hard hat to reduce the risk of head injuries during operation of this machine.
Wear non slip heavy-duty work gloves to improve your grip on the trimmer handle.
Wear snug-fitting clothes that also permit freedom of movement.
NEVER wear shorts!
Wear sturdy footwear with no slip soles to provide good footing.
Steel-toes safety boots are recommended.
Keep bystanders at least 15 meters (50 feet) away from the operating trimmer to reduce the risk of
being struck by falling or projected objects or debris.
Keep a proper footing and do not overreach - maintain your balance at all times during operation.
Always operate with both hands firmly gripping the machine.
IV. GETTING STARTED
4.1- Installing the hedge trimmer cutter head (see Fig.BC2)
! The cutter blades are very sharp. Do not handle the cutter assembly unless the
WARNING
protective blade cover is in place.
! Always wear gloves when working with or near the cutter assembly.
IMPORTANT
1. Make sure the cutter bar is locked in the storage/transport position (folded back) and the
protective cover is installed over the cutter blades.
2. Insert the lower tube (c) into the main pole tube (a) until shaft (b) aligns into position. Ensure
assembly is tight and secured.
3. With a screwdriver, check that all screws are correctly tightened (Fig.HT3).
The articulated hedge trimmer is not insulated against
electrical shock!
• Approaching or contacting electrical lines with the trimmer
could cause death or serious injury.
• Keep the trimmer at least 10 meters away from electrical
lines or branches that contact electrical lines.
Fig.HT3
1. Protective cover must be in place
2. Tighten the screw (if needed)
Page 61 / 99