Getting Started - Ribimex Ribiland PR4EN1T/2 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
4.1- Handle assembly (Fig.3)
1. Place unit on flat, hard and clean surface
2. With a Hex key, open the mounting collar.
3. Place handle over the tube.
Fix with the mounting collar.
4. Tighten firmly the screws.
4.2- Shoulder strap assembly (Fig.4)
Insert shoulder strap clip on the hook.
Adjust shoulder strap to your desired length.
4.3- Mixing fuel
1. Use only fresh, clean unleaded gasoline with an octane rating of 90 or above.
2. Mix all fuel with 2-cycle engine oil at a ratio of 25:1; i.e. for ex. Use 0.2liter of oil for 5liters of
gasoline.
!
CAUTION
This engine is to be operated on a 25:1 mixture consisting of unleaded gasoline and 2-cycle mixing
oil only.
Some gasolines contain alcohol as an oxygenate!
Oxygenated fuels may cause increased operating temperatures. Under certain conditions,
alcohol-based fuels may also reduce the lubricating qualities of some mixing oils. Never use any
fuel containing more than 10% alcohol by volume! When an oxygenated fuel must be used, fuel
containing an oxygenate such as MTBE is to be preferred over an alcohol based fuel.
Generic oils and some outboard motor oils may not be intended for use in high-performance air
cooled 2-cycle engines, and should never be used in a this engine
Important! Only mix enough fuel for your immediate needs!
If fuel must be stored longer than 30 days, it should first be treated with a stabilizer.
4.4- Filling the fuel Tank
1. Place the tank on a flat, level and clean surface.
2. Clear any dirt or other debris from around the fuel filler cap.
3. Remove the fuel cap, and fill the fuel tank with clean, fresh fuel mixture.
4. Install and firmly tighten the fuel cap.
5. Wipe up any spilled fuel from the powerhead before restarting
!
WARNING
• Always minimize the risk of fire when handling fuel!
• Always allow the product to cool before refueling!
• Wipe all spilled fuel and move the product at lease 3 meters (10 feet) from the fueling point
before restarting!
• Never smoke or light any fires near the product or fuels!
• Never place any flammable material near the engine muffler!
• Never operate the engine without the muffler and spark arrestor in place and properly
functioning!
• Never operate this machine if fuel system components are damaged or are leaking.
Fig.3
Fig.4
Page 41 / 99