Ribimex Ribiland PR4EN1T/2 Manuel D'instructions Et D'utilisation page 50

4. Put the attached bolt cover on the outer holder and secure it with the bolt (left screw) together
with the spring washer
4.5- Installing the nylon wire spool (Fig.BC6)
1. Set correctly the inner holder and the outer holder to the gear shaft
2. Screw the attached bolt (M8 left) into the gear shaft and secure it with the spanner
3. Screw the nylon cutter spool into the bolt by fixing the inner holder with the L-shaped (hex-key)
bar and tighten it manually.
NOTE: Keep bolls and washers to install the blade carefully so as not to lose them.
Fig.BC5
4.6- Wearing the Strap (Fig. BC7)
1. Hook the strap hook to hanger on the outer pipe.
2. Wear the strap so that the hook stays at your right hand side.
3. Adjust the length of the strap so that you can hold and operate
machine comfortably.
V. OPERATION
5.1- Intended use
- The product is intended for domestic use.
- The product is intended for cutting grass and trimming edges
5.2- Cutting operation
5.2.1- Metal blade usage (Fig.BC8)
Fig.BC5
1. Nut
2. Outer holder 1
3. Outer holder 2
4. Blade
5. Gear shaft
6. Bar (hex-key)
7. Inner holder
8. Gear case
Fig.BC6
Fig.BC6
1. Gear case
2. Bolt
3. Nylon cutter
spool
4. Nylon wire
Fig.BC7
1. Strap
Page 50 / 99