Ribimex Ribiland PR4EN1T/2 Manuel D'instructions Et D'utilisation page 49

any part must be replaced or any maintenance or repair work not described in this manual must be
performed, please contact the nearest authorized servicing dealer for assistance.
2. Under no circumstances should you ever take apart the brush cutter or alter it in any way. Doing
so might result in the brush cutter becoming damaged during operation or the brush cutter
becoming unable to operate properly.
3. Always be sure to turn off the engine before performing any maintenance or checking
procedures.
4. When sharpening, removing, or reattaching the blade, proper tools and equipment are required to
prevent injury.
5. When replacing blade or any other part or when replacing the oil or any lubricant, always be sure
to use products or products which have been certified for use with the brush cutter.
IV. GETTING STARTED
4- Set Up
4.1- Accessory
Insert the lower tube (c) into the main pole tube (a) until shaft (b) aligns into position. Ensure
assembly is tight and secured.
4.2- Gearcase
Check screws of gearcase and tighten if necessary. (Fig.BC3)
Fig.BC2 Fig.BC3
4.3- Safety guard
Attach the safety guard to the main tube (3), above the gearcase and fix it with the clamp and bolts
securely (Fig.BC4).
Fig.BC4a
1. Bolt
2. Clamp
3. Main tube
4. Safety guard
Fig.BC4a
Fig.BC4b
4.4- Installing the metal blade (Fig.BC5)
1. Set the inner holder to the gear shaft, and turn to fix with the attached L-shaped bar (hex-key).
2. Put the blade on the inner holder with letters to the gear case, and match correctly the hole of the
blade to the projection of the inner holder.
3. Set the outer holder to the gear shaft with the hollowed face to the blade.
Page 49 / 99