CAMPAGNOLO ERGOPOWER 7225251 Mode D'emploi page 22

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
7. INSTALLATION OF THE INTERFACE SENSOR
AND THE BUTTON
• Shift to the lowest gear (Fig. 35).
• Detach the Ergopower lever using
a 5 mm allen key (see Section 4
"Removal").
• Remove the plastic cover located
at the bottom of the body (Fig. 36).
• Note that the position of the rotary-
ring (A - Fig. 37) should be as illustra-
ted.
• The interface sensor with the black
rotary-ring is for the left lever, the
interface sensor with the white ring
(9s) or the red ring (10s) are for the
right lever.
• Carefully insert the interface sensor
into the lever, pushing gently on the
main part of the insert and on the
upper appendix at the same time. Be
sure that you do not confuse the right
and the left inserts.
42
35
36
37
A
OK!
NO!
ENGLISH
• Install the switch button onto the lever
as illustrated (Fig. 38). "DX" is for the
right lever and "SX" for the left.
In case you have installed it to the
wrong side, do not pull it out forcibly,
but remove the interface sensor first
and push the button inward.
• Reinstall the Ergopower lever to your
handlebar.
• For further information refer to the
ErgoBrain installation manual.
8. HOW TO REMOVE THE INTERFACE SENSOR AND THE BUTTON
• Remove the interface sensor, then push the button inward.
9. MAINTENANCE
• Casings are supplied pre-lubricated and do not require any additional
lubrication.
• Campagnolo
advises that Ergopower controls be checked by a specialist
®
mechanic every 3 years or every 30,000 Km (18,000 miles) and that you repla-
ce cables and casings every 2 years or after 20,000 Km (12,000 miles).
• In the event of competitive use, Ergopower controls should be checked
by a specialist mechanic and cables and casings should be replaced
every year or every 15,000 Km (9,000 miles).
• These distances are indicative and should be modified in accordance
with actual conditions of use (for example: racing, rain, salted Winter
roads, etc.). Check with your mechanic to select a schedule that is best
for you.
• Water and dirt are the most frequent causes of components damage.
Please keep your bicycle and all its components clean and dry.
ENGLISH
38
43

Publicité

Table des Matières
loading

Table des Matières