CAMPAGNOLO ERGOPOWER 7225251 Mode D'emploi page 18

NOTE
Ergopower controls are fitted with a pushbutton (A - Fig. 16) which holds
your brakes in the wide open position to facilitate wheel removal.
16
A
34
6. FITTING THE DRIVETRAINS
• Install the cable guide plate (inclu-
ded in the pack) under the bottom
bracket shell, as follows:
- position the washer (A – Fig. 17) in
the provided seat in the cable guide
plate.
- place the cable guide plate under
the bottom bracket shell and fix it by
means of the provided screw (B – Fig.
17) with a torque of 3-4 Nm.
• The cable casings of the rear derail-
leur (A - Fig. 18) have a diameter of 4.5
mm, while the brake cable casings (B
- Fig. 18) have a diameter of 5 mm.
• Depending on your frame, it may be
necessary to cut the rear brake casing
and install a casing lead end (not sup-
plied in your Ergopower package).
Note
• The casing must be cut so that the
end is squared and without altering its
cross section (Fig. 19). After cutting the
casing, check that you have restored
its roundness to ensure that there is no
friction between the cable and flatte-
ned areas.
WARNING!
Before cutting the casing, carefully
check that the length you choose
is suitable for the size of your frame.
Insufficient slack in the cable and
casing could affect your ability to turn
or control your bicycle, resulting in an
accident, personal injury or death.
ENGLISH ENGLISH
17
B
A
18
A B
ø 4.5 mm ø 5 mm
19
90º
OK!
90º
NO!
35