CAMPAGNOLO ERGOPOWER 7225251 Mode D'emploi page 20

• Pass the cable through the RH slot
on the cable guide plate located
underneath the bottom bracket box
(D - Fig. 25); insert the cable through
the pawl present on the chain stay
(A - Fig. 26).
• Fit a casing end (some frames requi-
re the use of the special casing end
- F - Fig. 3 - Page 28) on the 330 mm
- diameter ø 4.5 mm casing, pass the
cable through the casing and insert it
in the pawl on the right chain stay (A
- Fig. 26).
• Fit a casing end to the other end
of the casing and secure the cable
to the rear derailleur (refer to the
rear derailleur instruction manual for
proper attachment of the cable to
the derailleur).
Front derailleur cable and casing
• Fit the end of the casing (330 mm
long - diameter ø 4.5 mm) with the
casing end already fitted in the exter-
nal slot of the LH Ergopower control
unit (Fig. 20 - Page 36).
• Set the control at the smallest chain-
ring position by pressing lever (A - Fig.
27) repeatedly and fit the front derail-
leur cable (1,600 mm long - diameter
ø 1.2 mm) in the appropriate hole (B
- Fig. 28).
• Cut the casing so that it reaches the
casing retainer clamp on the frame
(A - Fig. 29).
38
25
�
26
A
WARNING!
Before cutting the casing, care-
fully check that the length you
choose is suitable for the size
of your frame. Insufficient slack
in the cable and casing could
affect your ability to turn or
control your bicycle, resulting in
an accident, personal injury or
death.
ENGLISH
• After cutting the casing at the
suitable lenght, fit a casing end
and insert the casing in the casing
retainer clamp (A - Fig. 29) on the
frame.
• Let the cable run into the casing.
• Pass the cable through the LH slot
on the cable guide plate (B - Fig.
30) located underneath the bottom
bracket box and secure the cable
to the front derailleur (refer to the
derailleur instruction manual for pro-
per attachment of the cable to the
front derailleur).
29
A
ENGLISH
27
A
28
B
30
�
39