CAMPAGNOLO ERGOPOWER 7225251 Mode D'emploi page 15

2. PACKAGING
The package contains the following articles:
• 2 Ergopower™ control levers (1 right & 1 left) (A - Fig. 3)
• 1 Front brake cable diameter ø 1.6 mm, length 800 mm (B - Fig. 3)
• 1 Rear brake cable diameter ø 1.6 mm, length 1,600 mm (B - Fig. 3)
• 1 Rear derailleur cable diameter ø 1.2 mm, length 2,000 mm (C - Fig. 3)
• 1 Front derailleur cable diameter ø 1.2 mm, length 1,600 mm (C - Fig. 3)
• 1 Front brake casing diameter ø 5 mm, length 580 mm (D - Fig. 3)
• 1 Rear brake casing diameter ø 5 mm, length 1,250 mm (D - Fig. 3)
• 2 Rear derailleur/front derailleur casings diameter ø 4.5 mm, length 680
mm (E - Fig. 3)
• 1 Rear derailleur casing diameter ø 4.5 mm, length 330 mm (E - Fig. 3)
• 1 Rear derailleur special casing end (F - Fig. 3)
• 4 Rear derailleur/front derailleur casing ends diameter ø 5.7 mm (G - Fig.
3)
• 1 cable guide plate (H - Fig. 3)
3
�
�
28
�
�
�
�
� �
�
ENGLISH
3. INSTALLATION
• Raise the support cover (A - Fig. 4) to expose the securing screw (B - Fig. 4).
• Loosen the Allen securing screw by 5 mm (B - Fig. 4) located on the
upper part of the body, so that the retaining band can be slid over the
non-taped handlebar without removing the band from the Ergopower
unit. Make sure that the arrow on the band faces towards the upper part
of the control unit (C - Fig. 5).
• If the support cover has been completely removed, moisten the inside
slightly with alcohol to facilitate installation on the control unit.
4
Min. ø 23,8 mm
Max. ø 24,2 mm
ENGLISH
5
C
A
B
10 N.m - 7,4 lb.ft
29