Secondary Areas - Programming Mode; Safety - Programming Mode; Change Password - Stiga Autoclip 221 Manuel D'utilisation

If the area to be mowed includes secondary areas based on the definition given in the chapter "Preparation and Marking the
Boundaries of the Work Areas", then it is necessary to program the secondary areas so the robot knows how to reach them and
how many times.
EN
SECONDARY AREA: function for defining the automatic mowing of a secondary area.
-
Percentage: allows setting the dimensions of the secondary
area to be mowed in respect to entire lawn surface. Below is a
table to use as a guide for configuring a secondary area:
•
10% indicates a very small area.
•
30% indicates an area which is approximately one third of
the entire garden.
•
50% indicates an area which is approximately half of the
entire garden.
•
80% indicates a secondary area which is bigger than the
primary area.
•
100% the robot will follow the perimeter wire to mow the
secondary area each time it exits the charging station.
-
Distance: this allows setting the distance necessary for the robot to reach the internal part of the secondary area following
the perimeter wire. It is recommended to measure half the distance of the secondary area to ensure that the robot starts
working inside that area.
-
Direction: indicates the shortest direction for reaching the secondary area. The direction can be clockwise or counter-
clockwise. The robot exits from the charging station and follows the wire in the indicated direction to reach the secondary
area.
-
Mode: indicates the method for reaching the secondary area. Use the "Follow wire" method when there are lots of obstacles
in the garden close to the perimeter wire (less than 2 m) or when there are tight areas to pass through (less than 2 m) to reach
the secondary areas. In all other cases use the "V-Meter" method.
•
"Follow wire". The robot reaches the secondary area positioning its wheels astride the perimeter wire.
•
"V-Meter". The robot reaches the secondary area running along the perimeter wire at an indicative distance from a few
cm to 1 m (3.2 ')..
SECONDARY AREA 2: function for defining the automatic mowing of secondary area number 2. This setting uses the same
configuration parameters as those used for secondary area 1.
SECONDARY AREA 3: (only for some versions, see "Technical Specifications"). Function for defining the automatic mowing of
secondary area number 3. This setting uses the same configuration parameters as those used for secondary area 1.
CHANGE PASSWORD: function for setting or changing the password.
-
No: the password entered does not need to be changed.
-
Yes: for entering or changing the password which will be used to start the robot. You will prompted to enter the following
information:
•
password: enter the old password (manufacturer's default 0000).
•
new password: enter the new password. The password must be different from 0000.
•
repeat password: enter the new password again.
User's manual
SECONDARY AREAS – PROGRAMMING MODE
SAFETY – PROGRAMMING MODE
secondary area 2
(20%, 30MT, Anti-clokwise)
anti-clockwise direction
26
primary area
secondary area 1
(30%, 60MT, clokwise)
clockwise direction