Adjustments; Adjustment Recommendations; Adjustment Of Cutting Height - Stiga Autoclip 221 Manuel D'utilisation

ADJUSTMENTS

EN
Important
The user must make any adjustments according to the procedures described in this manual. Do not make
any adjustments which are not expressly indicated in this manual. Any special adjustments, not expressly
indicated in this manual, must only be performed by personnel from the Manufacturer's authorised service
centre.
Before setting the cutting height of the blade, make sure the robot is safely off (see "Robot Safety Stop").
Important
Use protective gloves to prevent injuries to your hands.
1.
Turn over the robot and position it so as not to ruin the hood.
2. Turn the bracket (E) in a clockwise direction with the key
provided.
3.
Lift or lower the cutting unit (D) to set the desired cutting
height. The value can be measured using the graduated scale
found on the key provided.
Important
Do not use the robot to mow grass which is 1 cm
(0.40 ") higher than the cutting blade. Reduce the
cutting height gradually. It is recommended to
reduce the height by at least 1 cm (0.40 ") every 1-2
days until the ideal height is reached.
4. Once the adjustment has been made, turn the bracket (E) in a
counter-clockwise direction.
5. Turn the robot back over to its operating position.
User's manual

ADJUSTMENT RECOMMENDATIONS

ADJUSTMENT OF CUTTING HEIGHT

20
cutting unit (D)
(E)