Battery Charging On First Use - Stiga Autoclip 221 Manuel D'utilisation

5. Fasten the charging station (N) to the ground with the pegs (P).
If necessary, secure the charging station with screw anchors
(Q).
6. Install the power supply unit (A).
7. Connect the power cord (E) of the charging station (N) to the
power supply unit (A).
8. Connect the plug of the power supply unit (A) to the electrical
outlet.
9. If the LED of the transmitter flashes, the connection is correct.
Otherwise, find the anomaly (see "Troubleshooting Guide").
10. Replace the protection (L).
1. Place the robot inside the charging station.
2. Press the ON key and wait a few seconds for the robot to
turn on completely. Enter the password (if prompted) (See
"Password Entry"). Press "Enter" if the information messages
remain on the display.
3. After a few seconds, the "CHARGING" message will appear on
the display. Afterwards, the display will show other information
in rotation such as:
-
day of the week, Date;
-
programmed working times;
-
working time, total working time;
-
battery information.
4. Press the "PLAY/PAUSE" key. The "PAUSE" function appears
on the display. The batteries start the charging cycle.
5. At the end of charging, the robot can be programmed for initial
start-up (see "Programming Mode").
Important
On first use, always charge the batteries for at least 4 hours.

BATTERY CHARGING ON FIRST USE

19
pegs (P)
charging station (N)
transmitter (T)
H. min. 160 cm
(63.00 ")
power cord (E)
charging station (N)
STOP
RAIN SENSORS
E N T E R
"PLAY/PAUSE" KEY
ON
"ON" KEY
PLAY
HOME
PAUSE WORK
OFF
screw anchors (Q)
current power
supply unit (A)
Perimeter
wire
protection (L)
User's manual
EN