Robot Safety Stop; Automatic Return To The Charging Station; Use Of The Robot In Closed Areas With No Charging Station - Stiga Autoclip 221 Manuel D'utilisation

Masquer les pouces Voir aussi pour Autoclip 221:

Table des Matières

Les langues disponibles

During use, it may be necessary to stop the robot. In normal conditions, the robot can be stopped with the "OFF" key. In case

of danger or when performing any maintenance, it is necessary to stop the robot in safe conditions in order to prevent the blade

from accidentally starting. Press the "STOP" key to stop the robot. Disconnect the power plug from the electrical outlet.

Important

The robot safety stop is necessary during

maintenance and repairs (for example, blade

replacement, cleaning operations, etc.).

To start, proceed as indicated:

position the robot inside the cutting area;

press the ON key and wait a few seconds for the robot to

turn on completely. Enter the password (if prompted) (See

"Password Entry"). Press "Enter" if the information messages

remain on the display. The display will light up, "Pause" is

indicated shortly after, the robot is now in the pause state;

press the "PLAY/PAUSE" key.

If the robot is started up outside of the cutting area, the blade

motor will not start and after briefly searching for the signal, the

robot will show "OUT OF BORDER" on the display. Press "OFF",

position the robot inside the cutting area and carry out the start up

procedure again.

The robot stops the work cycle if the following conditions are verified.

End of working time: at the end of the working time, the robot automatically returns to the charging station and starts

operating again according to what has been programmed (see "Programming Mode").

Rain: with the function active, the robot returns to the recharging station automatically and will start working again as

programmed (see "Programming mode").

Battery to be charged: the robot automatically returns to the charging station.

Lawn mowed (only for some versions, see "Technical Specifications): if the sensor detects that the lawn has already been

mowed, it automatically returns to the charging station and starts operating again according to what has been programmed

(see "Programming Mode").

USE OF THE ROBOT IN CLOSED AREAS WITH NO CHARGING STATION

(Only for some models, see "Technical Specifications"). The start-

up of the robot in "closed area" mode is for mowing closed areas

which are delimited by the perimeter wire and which have no

charging station.

Warning – Caution

Carry the robot using the handle provided. Do not

grab the robot by the body and always use the

handle provided.

Position the robot inside the work area at a minimum distance

of 100 cm (39.37 ") from the perimeter wire and from any other

obstacle.

User's manual