Areas Of Use - Stiga PARK SILENT Mode D'emploi

All manuals and user guides at all-guides.com
4. Start position – the electric start motor
is activated when the key is turned to the
spring-loaded start position. Once the en-
gine has started, let the key return to oper-
ating position 3.
11.4.8 Power take-off (4,5:K)
The power take-off must never be
engaged when the front-mounted
implement is in transport position. This
will destroy the belt transmission.
A lever for engaging and disengaging the power
take-off for operating front-mounted accessories.
Two positions:
1. Lever in forward position – power take-
off disengaged.
2. Lever in backward position - power
take-off engaged.
11.4.9 Hour meter (2:P)
Indicates the number of working hours. Only
works when the engine is running.
11.4.10Clutch release lever
A lever for disengaging the variable transmission.
2WD is equipped with a lever, connected to the
rear axle. See (6:R).
The disengagement lever must never be
between the outer and inner positions.
This overheats and damages the trans-
mission.
The levers enable the machine to be moved by
hand without the help of the engine. Two positions:
1. Lever in the inner position –
transmission engaged for normal
operation.
2. Lever in the outer position –
transmission disengaged. The
machine can be moved by hand.
The machine may not be towed over long distances
or at high speeds. The transmission could be dam-
aged.
The machine must not be operated with
the forward most lever in the outer po-
sition. Risk of damage and oil leakage in
the front axle.
11.4.11Seat (8:T)
The seat can be folded and adjusted front-
rear. The seat can be adjusted as follows:
1. Move the control lever (8:S) upwards.
2. Set the seat to the desired position.
3. Release the control lever (8:S) to lock
the seat.
ENGLISH
The seat is equipped with a safety switch that is
connected to the machine's safety system. This
means that certain dangerous activities are not pos-
sible when there is nobody sitting on the seat. Also
see 13.4.2.
11.4.12Engine casing (2:U)
In order to access the fuel cock, battery
and engine, the machine has an engine
casing that can be opened. The engine cas-
ing is locked with a rubber strap.
The engine casing is opened as follows:
1. Undo the rubber strap (2:V) at the front edge of
the casing.
2. Carefully lift the engine casing back.
Close in the reverse order.
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.

12 AREAS OF USE

The machine may only be used for the following
tasks using the genuine STIGA accessories stated.
Work Accessories, STIGA genuine
Mowing Using mowing decks:
95 C, 105 C and with flail mow-
er.
Sweeping Using brush unit or collector
brush unit. The use of a dust
guard is recommended with the
first option.
Snow clearance Using snow blade or snow
thrower Snow chains and frame
weights are recommended.
Grass clipping and Using towed collector 30" or
leaf collection 42". Pro Cart.
Grass and leaf Using dump cart Standard, Maxi
transport or Combi.
Sand spreading Using sand spreader. Can also
be used for spreading salt. Snow
chains and frame weights are
recommended.
Weeding on gravel Using front-mounted hoe.
paths
Lawn edge trim- Using edge trimmer.
ming
Moss scarification Using moss scarifier.
The maximum vertical load on the towing hitch
must not exceed 100 N.
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
EN
27