Stiga Autoclip 221 Manuel D'utilisation page 43

GARDEN WITH CENTRAL HOUSING: CONNECTED WITH DRIVEWAY OR SURROUNDED
A
< 70cm
B
C
Notes:
the example on the right differs from the one on the left, because of the absence of the driveway which connects the street to the
home. In the example on the right, the home is isolated in the middle of the garden as a flowerbed or a pool. It is not possible to
install the charging station too close to the home, but only along the edge of the garden.
References:
A. the bush has to be delimited by the perimeter wire. If its distance is less than 70cm respect to the perimeter wire installed
along the external edge of the garden, it is necessary to leave 20cm between the outgoing and incoming wires.
B. the passage must not be narrower than 2 m. In case of lower distance, it is necessary to install a Recall on wire to ensure a
correct re-entry to the charging station of the robot.
C. work secondary exiting: See "Programming".
D. the three trees are at a distance of more than 70cm respect to perimeter wire installed along the edge of the garden. It may
be avoided to delimit the trees, unless there are protruding roots or unless the trees are too flexible to ensure the correct
recognition of the obstacle by the robot.
E. marking boundary of central housing: lay the outgoing and incoming perimeter wires one above the other for the home
delimitation.
F. it is recommended to perform an arrow for quick re-entry to the charging station preceded by a recall on wire. The robot will
find the shortest way to reach the charging station by itself.
G. charging station: it has to be installed along the edge of the garden but not along the areas delimited with the wire inside of
the garden itself.
Programming:
•
secondary areas:
-
area 1 - C:
-
percentage: 50%;
-
direction: clockwise;
-
distance: 70m (distance between the charging station and the point "C");
-
mode: V-Meter.
COMPLETELY BY LAWN
A
< 70cm
D
> 70cm
C
41
F
B
E
0 cm 0 cm
EN
G
D
> 70cm
User's manual