Settings - Programming Mode; Auto Setup - Stiga Autoclip 221 Manuel D'utilisation

RAIN SENSOR: Function for setting the robot in case of rain.
•
Enable: in case of rain, the robot returns to the station and remains in
EN
"charging" mode. At the end of the charging cycle, the robot only starts mowing
again if it has stopped raining.
•
Disable: in case of rain, the robot continues to mow.
AUTO SETUP: (only for some versions, see "Technical Specifications"), function
for automatically reducing the robot's mowing time based on the conditions of the
lawn.
•
Enable: the robot reduces the working time based on the conditions of the
grass. When the lawn surface is mowed, the machine automatically sets a
rest period which delays subsequent departures from the charging station.
However, the robot will operate within the set working times.
•
Disable: the robot will work according to the set time and until the batteries
run out.
BACK TO RECHARGE: allows selecting the method for the robot's return to the
charging station.
1. "Follow wire". The robot returns to the charging station by positioning the
wheels on either side of the perimeter wire.
2. "V-Meter". The robot runs along the perimeter wire at an indicative distance
ranging from a few centimetres to one meter (3.2 '), touching it every now
and again in the curved sections until it recognises the recall to the charging
station. Refer to the "Installation" chapter.
DATE: function for setting the date.
TIME: function for setting time.
User's manual
SETTINGS – PROGRAMMING MODE
24
RAIN SENSOR:
E N T E R
ON
E N T E R
DATE DD/MM/YY
MON 00 / 00 / 00
E N T E R
ON