Use And Operation; Obligations For Use; Description Of Robot Commands; Menu Access - Stiga Autoclip 221 Manuel D'utilisation

USE AND OPERATION

Important
-
When using the robot for the first time, please read the manual carefully and make sure you have
understood it completely; in particular, all the information on safety.
-
The product must only be used for its intended purpose as described by the Manufacturer. Do not
tamper with any device to obtain different operating performances.
-
Avoid using the robot and its peripherals in bad weather conditions especially when there is a risk of
lightning.
The illustration shows the position of the control functions on the
machine.
A. DISPLAY: lights up to show all the functions.
B. ON: press to turn on the lawnmower.
C. OFF: press this key to stop the robot, the display turns off.
D. PLAY/PAUSE: press to stop the mower, leaving the display
on "stand-by"; in this way, the mower can be programmed.
Press again to restart the mower. If the key is pressed while
the mower is charging, the mower does not resume working
until it is pressed again and the word "PAUSE" disappears from
the display.
E. HOME/WORK: press this key to allow the mower to return to
its station and, consequently, to start recharging the batteries.
If pressed while the robot is being charged, the robot interrupts
the charging cycle and starts operating again.
F. "+" KEY: during operation, press this key to restart the blade which was previously stopped. During programming, press this
key to increase the values shown in the menu.
G. ENTER: during operation, press this key to turn on the spiral function. During programming, press to confirm and memorise
the selection.
H. "-" KEY: during operation, press to stop the blade. During programming, press to decrease the values shown in the menu.
I. STOP: press to stop the mower safely. Only use in case of imminent danger and to perform maintenance on the robot.
The robot functions can be programmed via the different functions of each menu. The table reports the list of menus available
with the relative functions.
To program the robot, proceed as follows:
• lift the display protection;
• press the ON key and wait a few seconds for the robot to turn on completely. Enter the password (if prompted) (See
"Password Entry"). Press "Enter" if the information messages remain on the display;
• if the robot is turned on when inside the charging station, after a few seconds the message "CHARGING"appears on the
display, then press the "PLAY/PAUSE" key;
• the "PAUSE" function now appears on the display;
press the "ENTER" key. This allows entering into programming menu and the "SETTINGS" function appears on the display.
•

OBLIGATIONS FOR USE

DESCRIPTION OF ROBOT COMMANDS

MENU ACCESS

21
STOP
"STOP" KEY (I)
RAIN SENSORS
" – " (H) KEY
DISPLAY (A)
(G) "ENTER" KEY
E N T E R
" + " (F) KEY
"PLAY/PAUSE" KEY (D)
ON
"ON" KEY (B)
PLAY HOME
"HOME/WORK" (E) KEY
PAUSE WORK
"OFF" (C) KEY
OFF
• THIS KEYBOARD IS ONLY AN EXAMPLE
EN
User's manual