After Use; Shutting Down The Diesel Engine; Shutting Down The Propane Engine; Shutting Down The Gasoline / Petrol Engine - Advance CS7000 Mode D'emploi

A-26 / ENGLISH

AFTER USE

1 Raise the scrub brushes and the brooms.
2 Shake the dust control lter and empty the hopper.
3 Drain and ush the recovery tank. Check that the drain hose cap is sealed.
4 Flush the vacuum hose and squeegee by opening the recovery tank lid and running water down the pickup tube on the rear of the tank.
SERVICE NOTE: The recovery tank can be tipped out to the side for cleaning after emptying. Unlatch the Recovery Tank Tip-Out Lock (3)
between the solution and recovery tank and then pull out on the tank with grip (25) until the tank reaches the end of its tether.
5 Remove and clean the squeegee tool.
6 Remove and clean the scrub brushes. Rotate the scrub brushes.
7 Wipe the machine with a damp cloth.
8 Perform all required maintenance before storage.
9 Move the machine to a clean, dry storage area.
10 Apply the parking brake.
11 Store the machine with the brooms, the squeegee and the scrub brushes in the UP position, and the tank covers open so that the tanks can
air out.
REPORT ANY DEFECT OR MALFUNCTION NOTED DURING OPERATION TO AUTHORIZED SERVICE OR MAINTENANCE PERSONNEL.

SHUTTING DOWN THE DIESEL ENGINE

1 Put all controls to the OFF position.
2 Raise the squeegee, the scrub brushes, and the brooms.
3 Apply the Parking Brake (38).
4 Turn the Key Ignition Switch (A) OFF and remove the key.
SHUTTING DOWN THE LP ENGINE
1 Put all controls to the OFF position.
2 Raise the squeegee, the scrub brushes, and the brooms.
3 Turn the service valve on LP fuel tank OFF.
4 Let the engine idle until all the LP gas is dispelled from the line.
5 Apply the Parking Brake (38).
6 Turn the Key Ignition Switch (A) OFF and remove the key.

SHUTTING DOWN THE GASOLINE / PETROL ENGINE

1 Put all controls to the OFF position.
2 Raise the squeegee, the scrub brushes, and the brooms.
3 Apply the Parking Brake (38).
4 Turn the Key Ignition Switch (A) OFF and remove the key.
IMPORTANT NOTE:
During normal operation the engine will continue to run for a short period of time (1-3 seconds) after turning the key OFF
until all fuel is dispelled from fuel system.
CHECK HYDRAULIC OIL
To check the hydraulic oil level, swing open the Right Side Door (35) and lift out the Lower Cover (34). The Hydraulic Oil Reservoir (49) will be
visible in the area above the front tire. Look through the translucent reservoir to check the oil level it should be between the MIN and MAX lines.
See Figure 10.
If the oil level is below the MIN line with the hopper
in the down position you will need to add oil to the
reservoir. Raise the hopper and engage the hopper
safety bar to access the hydraulic oil reservoir ll cap.
Note: With the hopper raised some oil has entered
the cylinder causing the oil level to drop, DO NOT ll
the reservoir to the MAX line with the hopper raised.
Add 10W30 motor oil until the oil is at the MIN level
line. Change the oil if major contamination from a
mechanical failure occurs.
A-26 - FORM NO. 56041979 - CS7000
FIGURE 10
revised 4/2013