After Use; Maintenance Schedule - Advance HydroCat 5015G Mode D'emploi

AFTER USE

1 Move the machine to a designated waste water "Disposal Site"..
2 Empty the debris tray. Open the Outer Access Door (13) and the Inner Access Door (15). Slide the Debris Tray (14) out of the machine. Empty the
tray, and fl ush it with water to clean out the perforations.
3 Empty and rinse the recovery tank. Open the left rear access door. Remove the drain hose from its hanger, remove the plug and empty the tank.
Open the Recovery Tank Cover (23) and tip the tank for sludge removal. Flush the tank and drain hose with clean water. Put the drain hose back on
its hanger.
4 Empty and rinse the solution tank. Open the Right Rear Access Door (19) and remove the Solution Drain Hose (17). Direct the hose to a fl oor drain
or desired container and pull the plug to empty the tank. Flush the tank and drain hose with clean water.
5 Clean the squeegee tool. Remove the Squeegee Tool (16) and rinse under running water. Inspect the blades for damage. Reverse or replace the
blades if they are nicked, torn or worn to a radius.
6 Flush the vacuum hose and squeegee tool inlet. Back the machine over a fl oor drain, then run water down through the pick-up tube in the recovery
tank (on the left side of the tank from the rear of the machine).
7 Clean the scrub brushes. Remove the four scrub brushes (9) and rinse them under running water. Inspect the brushes for wear and replace if neces-
sary. Rotate the brushes; move the inner brushes to the outside position, and the outside brushes in for more even brush wear.
8 Perform any required maintenance.

MAINTENANCE SCHEDULE

9 Move the machine to a storage area. Store the machine in a clean, dry place with the tank covers open.
To Shut Down the Gasoline Engine
1 Raise the brushes, broom and squeegee, turn all controls OFF, and take your foot off the Drive Pedal.
2 Place the Engine Speed Switch in IDLE.
3 Turn the Key Ignition Switch OFF and apply the Parking Brake.
To Shut Down the LP-Gas Engine
1 Raise the brushes, broom and squeegee, turn all controls OFF, and take your foot off the Drive Pedal.
2 Turn OFF the service valve on the LP-Gas Tank.
3 Run the engine until all LP-Gas is dispelled from the line.
4 Turn the Key Ignition Switch OFF and apply the Parking Brake.
29 - FORM NO. 041357 / HYDRO-RETRIEVER 5015G/P
MAINTENANCE ITEM
Check the Air Filter Service Indicator
Check the Engine Oil Level
Check the Hydraulic Oil Level
Inspect the Skirts
Inspect the Recovery Tank Gaskets
Check the Engine Coolant Level
Complete Impeller Maintenance
Lubricate the Impeller Grease Fittings
Complete Broom Maintenance
Change the Engine Oil & Filter
Lubricate the Steering Grease Fittings
Check the Broom Pattern
Blow Dust from the Radiator & Oil Cooler
Rotate the Broom
DAILY 50 HOURS 100 HOURS
X
X
X
X
X
X
X
X
X
X
X
X
X
X