Charging The Battery (Battery Models) - Advance CS7000 Mode D'emploi

CHARGING THE BATTERY (BATTERY MODELS)

Charge the battery each time the machine is used, or whenever the Battery Low Indicator (C12) is displayed.
To Charge the Battery...
1 Unlatch the Battery Compartment Latch (20) and open the door to provide proper ventilation.
2 Disconnect the battery from the machine (AB) and connect the charger plug to the battery plug.
3 Follow the instructions on the battery charger.
4 Check the uid level in all battery cells after charging the battery. Add distilled water, if necessary, to bring the uid level up to the bottom of
the ller tubes.
WARNING!
Do not ll the battery before charging.
Only charge battery in a well-ventilated area.
Do not smoke while servicing the battery.
CAUTION!
To avoid damage to oor surfaces, always wipe water and acid from the top of the battery after charging.
CHECKING THE BATTERY ELECTROLYTE LEVEL
Check the electrolyte level of the battery at least once a week.
After charging the battery, remove the vent caps and check the electrolyte level in each battery cell. Use distilled water to ll the battery to the
bottom of the ller tube.
Do not over- ll the battery!
CAUTION!
Acid can spill onto the oor if the battery is over lled.
Tighten the vent caps. If there is acid on the battery, wash the tops of the battery with a solution of baking soda and water (2
tablespoons of baking soda to 1 quart of water).
ENGLISH / A-29
FORM NO. 56041979 - CS7000 - A-29