Jacking The Machine; Transporting The Machine; Towing Or Pushing A Disabled Machine - Advance CS7000 Mode D'emploi

ENGAGING THE PARKING BRAKE
CAUTION!
When parking on an incline, turn the steering wheel fully in one direction such that if the parking brake were to be accidentally
released or fail the machine would not roll and cause damage or bodily injury, if necessary, block the wheels.
A - To Engage Parking Brake:
1. Press the Brake Pedal (38) completely.
2. With the brake pedal pressed, rotate your foot to engage the Parking Brake Pedal (38A).
B - To Release Parking Brake:
1. Press the Brake Pedal (38) to disengage the parking brake pedal.
FIGURE 2

JACKING THE MACHINE

CAUTION!
Never work under a machine without safety stands or blocks to support the
machine.
• When jacking the machine, do so at designated locations (Do Not jack on the hopper)
- see Jack Point / Tie Down Point locations (33).

TRANSPORTING THE MACHINE

CAUTION!
Before transporting the machine on an open truck or trailer, make sure that . . .
• All access doors are latched securely.
• The machine is tied down securely - see Jack Point / Tie Down Point locations (33).
• The machine parking brake is set.

TOWING OR PUSHING A DISABLED MACHINE

CAUTION!
If the machine must be towed or pushed, make sure the Key Switch is in the Off position and do not move the machine faster than a
normal walking pace (2-3 mph, 3-5 kph) and for short distances only.
A second option which will allow for steering while pushing or towing the machine is to do the following:
-Turn the Key Switch (A) ON while pressing and holding both the Speed Switch (K) and the High-Pressure Wash Switch (N) for two
seconds.
revised 8/2015
38
FIGURE 2.2
ENGLISH / A-7
38A
Jack Point / Tie Down Point symbol
FORM NO. 56041979 - CS7000 - A-7