Charging The Battery Pack (Hybrid Models) - Advance CS7000 Mode D'emploi

A-30 / ENGLISH

CHARGING THE BATTERY PACK (HYBRID MODELS)

The engine runs a generator which is the main source of electrical power. The battery pack (32) is used as a back-up. If the engine is not running,
the machine can operate for a limited time using only the battery pack. Charge the battery pack whenever the Battery Low Indicator (C12) is
displayed (signifying a low-voltage cutout state). The battery pack can be recharged by running the engine and scrubbing with the machine for at
least four hours. An alternative is to follow the steps below to charge the battery pack using a shelf charger.
To Charge the Battery Pack...
1 Unlatch and open the Right Side Door (35).
2 Pull the yellow Handle (DG) to disconnect the battery pack from the machine at plug (DH).
3 Connect the charger plug to the battery plug (DH).
4 Follow the instructions on the battery charger; use an appropriate charger for gel batteries.
CAUTION!
Only use an appropriate charger designed for use with gel type batteries.
Never leave the machine in a low-voltage cutout state overnight without charging the battery pack.
A-30 - FORM NO. 56041979 - CS7000
revised 6/2011