Side Broom Maintenance - Advance CS7000 Mode D'emploi

SIDE BROOM MAINTENANCE

The side brooms move dirt and debris away from walls or curbs and into the path of the main broom. Adjust the side brooms so that the bristles
are contacting the oor from the (FG) to (FH) area shown in Figure 14 when the broom is down and running.
To adjust the Side Broom...
1 Press the One-Touch™ Sweep Switch (Y) to lower the side brooms. DO NOT move the machine.
2 See Figure 13. To adjust, press the Broom Select Switch (AA) once. The LCD Display (C) will show the side broom symbol. Press and hold
the Broom Height Raise Switch (Z) to raise the side brooms or Broom Height Lower Switch (BB) to lower the side brooms. After 10 seconds
without adjustment the side brooms will be set at this position and exit the adjustment menu.
NOTE: The machine should be stored with the Side Broom(s) in the raised position. The Side Broom(s) should be replaced when the bristles are
worn to a length of 3 inches (7.62 cm) or they become ineffective.
To replace the Side Broom...
1 Raise the Side Broom(s).
2 Reach under the Side Broom and remove the large Thumb-Nut Weldment holding the side broom on and remove the broom and plastic disc.
NOTE: The right side Thumb-Nut has right handed threads and the left side thumb-nut has left handed threads.
3 Install the new broom and plastic disc by aligning the three alignment pins and pushing on. Re-install the Thumb-Nut and tighten.
FIGURE 14
ENGLISH / A-33
FORM NO. 56041979 - CS7000 - A-33