Hopper Dust Control Filter - Advance CS7000 Mode D'emploi

HOPPER DUST CONTROL FILTER

The hopper dust control lter must be cleaned regularly to maintain the ef ciency of the vacuum system. Follow the recommended lter service
intervals for the longest lter life.
CAUTION!
Use only the approved Advance high capacity dust control lter in this machine. Use of standard pleated lters will result in
insuf cient air ow, inadequate clean shaking, and potential machine damage.
Wear safety glasses when cleaning the lter.
Do not puncture the paper lter.
Clean the lter in a well-ventilated area.
To remove the hopper dust control fi lter...
1 See Figure 16. Unlatch the Hopper
Cover Latches (16) and lift the Hopper
Cover.
2 Loosen the two Thumb Nuts (HA), then
slide the Filter Shaker Motor Assembly
(HB) to the left and lift it out of the
hopper.
3 Hang the shaker assembly on the hopper
cover Hinge Hook (HC).
4 Inspect the top of the Hopper Dust
Control Filter (17) for damage. A large
amount of dust on top of the lter is
usually caused by a hole in the lter or a
damaged lter gasket.
5 Lift the Hopper Dust Control Filter (17)
out of the machine.
6 Clean the fi lter using one of the
methods below:
Method "A"
Vacuum loose dust from the lter. Then
gently tap the lter against a at surface
(with the dirty side down) to remove
loose dust and dirt. NOTE: Take care
not to damage the gasket.
Method "B"
Vacuum loose dust from the lter. Then
blow compressed air (maximum pressure
100 psi) into the clean side of the lter (in
the opposite direction of the air ow).
Method "C"
Vacuum loose dust from the lter. Rinse
the lter under a gentle stream of water
(maximum pressure 40 psi). Let the lter
dry completely before putting it back
into the machine. It is recommended to
have a spare lter on hand to use while
the washed lter is drying out.
7 Keep Ledge (HD) clean of any dust or
debris, this is where the lter gasket
contacts the hopper.
8 Follow the instructions in reverse order to
install the lter. If the gasket on the lter
is torn or missing, it must be replaced.
NOTE: Be sure to reinstall so that the air
ow decal is pointing up as shown.
revised 6/2011
ENGLISH / A-35
FIGURE 16
FORM NO. 56041979 - CS7000 - A-35