After Use; Maintenance Schedule; Lubricating The Machine; Steering Chain Tension - Advance Advolution 2710 Mode D'emploi

A-12 / ENGLISH

AFTER USE

1 Raise the Pad Drive Deck (1), then drive the machine to a service area.
2 Turn the Master Key Switch (A) OFF (O) and remove the key.
3 Remove the burnishing pad, rinse the pad with warm water and hang it up to dry. NOTE: Allow pad to dry completely before using again.
4 Check the Dust Collection Bag (5) if over half full or damaged remove and replace with a new bag.
5 Check the maintenance schedule and perform any required maintenance.
6 Wipe the machine with a damp cloth, then store the machine in a clean, dry place.

MAINTENANCE SCHEDULE

Clean all dust and debris from the pad drive motor
Check Carbon Brush Wear On Pad/Wheel Drive/ Actuator Motors
NOTE: Refer to the Service Manual for more detail on all maintenance items mentioned in this manual.

LUBRICATING THE MACHINE

Locations requiring periodic oiling are:
Qty 1 - Steering Wheel Shaft Universal Joint (oil hole or port)

STEERING CHAIN TENSION

Inspect once a month and make adjustments if needed (refer to the service manual for detailed instructions).

ELECTROMAGNETIC BRAKE

See Figure 4. The Drive / Steer Wheel Assembly (14) has a built in electromagnetic brake that
is engaged whenever the Master Key Switch (A) is OFF or the FWD / REV Drive Pedal (8) is in
the neutral position. This brake can be manually over ridden if necessary by inserting a medium
to large screwdriver behind the Yoke (AA) as shown. This should only be done in the event you
need to push or pull the unit.
A-12 - FORM NO. 56041634 - Advolution™ 2710
MAINTENANCE ITEM
Charge Batteries
Check/Clean/Replace Burnishing Pad
Check/Replace Dust Collection Bag
Check Battery Water Level(s)
Check/Replace Pad Shroud Skirt
Steering Chain Tension
Lubrication
Daily Weekly Monthly
X
X
X
X
X
X
X
X
Yearly
X
FIGURE 4
revised 8/13