Adding/Deleting Somfy Io Control Points And Io Sensors; Modifying The End Limits - SOMFY HOME MOTION J4 io Notice Installateur

7.2. Adding/Deleting Somfy io control points and io sensors

Refer to the corresponding guide.

7.3. Modifying the end limits

7.3.1. Modifying the upper end limit
• Place the blind in the intermediate position.
• Press the Up and Down buttons for 5 seconds the blind
moves briefly.
• Press the Up button (The blind rotates, stops, then conti-
nues to turn in the up direction) until the required end of
travel is reached (The blind will continue to rise after the
control point is pressed for 3 seconds).
• Stop the blind in the required position (If the end of travel
has been set on the mushroom, the effective end of travel
will be stored slightly below the mushroom).
• Press the Down button.
The blind will move briefly to confirm storage.
Note: If a new end of travel needs to be set beyond the
existing end of travel, the blind will stop itself at the
existing end of travel. It will be necessary to press the
control point again to go past this existing end of travel.
7.3.2. Modifying the lower end limit
• Place the blind in the intermediate position.
• Press the Up and Down buttons for 5 seconds the blind
moves briefly.
• Press the Down button (the blind will turn, stop, then conti-
nue in the down direction) until the required lower end of
travel is reached (the blind will continue to lower when the
control point is pressed for 3 seconds).
• Stop the blind in the required position.
• Press the Up button.
The blind will move briefly to confirm storage.
Note: If a new end of travel needs to be set beyond the
existing end of travel, the blind will stop itself at the
existing end of travel. It will be necessary to press the
control point again to go past this existing end of travel.
68
© 2011 Somfy SAS. All rights reserved. 11/2011