Adding/Deleting Rts Sensors - SOMFY Sunea 40 RTS DC Notice

EN
1] Position the motorised product at the mid-height position.
2] To activate the "Closing force" function, make two successive presses:
• Firstly, press the my and Up buttons briefly and simultaneously, with no
moving of the motorised product.
• Secondly, press and hold the my and Up buttons simultaneously, until the
motorised product moves up and down.
ð The drive is now in programming mode for only 10 seconds. By default,
the drive is factory set at the medium level.
3] To increase the closing force, press the Up button until the motorised
product makes a slow movement:
ð The cassette's closing force has moved up a level.
4] To decrease the closing force, press the Down button until the motorised
product makes a slow movement:
ð The cassette's closing force has moved down a level.
5] To confirm the new setting, press the my button until the motorised product
moves up and down.
g The "Closing force" function is reset.

2.3.8.Adding/Deleting RTS sensors

1] To add or delete an RTS sensor, press and hold the PROG button on the
programmed control point until the motorised product briefly moves up and
down.
2] Briefly press the PROG button on the RTS sensor to be added/deleted: the
motorised product briefly moves up and down.
g The sensor is added/deleted.
NOTICE
If the RTS sensor on an installation is changed or deleted, it is important to delete it from the memory of all the drives
in which it was programmed: perform step 1 with a programmed control point, then perform step 2 with the sensor to
be deleted.
12
5113030C_Sunea 40 RTS DC.pdf 12
1]
3]
5]
1]
2 s
PROG.
2]
0.5 s
PROG.
©
Copyright 2020 SOMFY ACTIVITES SA. All rights reserved.
Sunea 40 RTS DC
2]
0.5 s
4]
10/19/2020 5:49:32 PM