Use And Maintenance; Open And Close Buttons; Stop Function; Favourite Position (My) - SOMFY Glydea Ultra RTS Notice

EN
2.4.4. Erasing the memory of the motor (Fig O)
This reset deletes all control points, all the sensors and all the end limit settings, and resets the motor's favourite
position (my).
To reset the motor, use a pin to press and hold the S button until the motorised product moves 3 times.
All the settings are erased.

3. USE AND MAINTENANCE

This drive is maintenance-free

3.1. OPEN AND CLOSE BUTTONS

Pressing the Open or Close button fully opens or closes the motorised product.

3.2. STOP FUNCTION

The motorised product is moving.
Briefly press my: the motorised product stops automatically.
3.3. FAVOURITE POSITION (
The motorised product is stopped.
Briefly press my: the motorised product starts to move, and stops in the favourite position (my).
To modify or delete the favourite (my) position, see the section entitled "Additional settings"

3.4. ADDITIONAL SETTINGS

3.4.1. Recording the favourite position (my) (Fig S)
1) Press Open or Close to move the motorised product to the desired favourite postion (my)".
2) Press my until the motorised product moves: the desired favourite position (my) has been programmed.
3.4.2. Deleting the favourite position (my) (Fig T)
1) Press my: the motorised product starts to move, and stops in the favourite position (my).
2) Press my again until the motorised product moves: the favourite position (my) is deleted.
3.4.3. Adding/Deleting Somfy control points (Fig U)
1) Find an RTS control point programmed in the motor.
Press & hold the RTS programmed control point (A) PROG button or the receiver prog button until the motorised product
moves, the motor is in programming mode.
2) Quickly press the RTS control point (B) PROG button to add or delete, the motorised product moves & the RTS control
point (B) is programmed or deleted from the motor.
3.4.4. Modifying the motor rotation direction (Fig V)
Move the motorised product away from the end limits.
1) Press the Open and Close buttons of the RTS control point simultaneously until the motorised product moves.
2) Press the my button until the motorised product moves to reverse the rotation direction.

3.5. TIPS AND RECOMMENDATIONS FOR USE

3.5.1. Questions about the Glydea Ultra ?
Observations
The motorised product
does not operate.
If the motorised product still does not work, contact a motorisation and home automation professional.
3.5.2. Replacing a lost or broken Somfy control point
To replace a lost or broken control point, contact a Somfy motorisation and home automation professional.

4. TECHNICAL DATA

Power supply
Radio frequency
Operating temperature
Index protection rating
Safety level
6
(Fig P)
(Fig Q)
)
(Fig R)
my
Possible causes
The control point battery is weak.
The motorisation is in thermal protection mode.
Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved
Solutions
Check whether the battery is weak and
replace it if necessary.
Wait for the motor to cool down.
100V - 240V
433.42 MHz
0°C to + 60°C
IP 30
Class I
.