FITTING A PLUG – U.K. AND IRELAND ONLY
If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a
plug of the correct type. If the plug is unsuitable, it should be dismantled and removed from the supply
cord and an appropriate plug fitted as detailed below. If you remove the plug it must not be connected
to a 13 amp socket and the plug must be disposed of immediately.
WARNING – THIS APPLIANCE MUST BE EARTHED
CAUTION: If the terminals in the plug are not marked or if
you are unsure or in doubt about the installation of the plug
please contact a qualified electrician.
If a 13A 3-pin plug is fitted, it must be an ASTA approved
plug, conforming to BS1363 standard. Replacement fuses
must be BSI or ASTA BS1362 approved.
The wires in the mains lead are coloured as such:
GREEN AND YELLOW
BROWN
BLUE
Please note that the colour of these mains wires may not correspond with the colour markings
that identify the terminals in your plug. Please proceed as follows:
The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked
with the letter 'E' or by the earth symbol ( ) or coloured GREEN or GREEN AND YELLOW.
The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or
is coloured RED.
The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is
coloured BLACK.
English
Français/French
Deutsch/German
Italiano/Italian
Dutch/Nederlands
Svenska/Swedish
Suomi/Finnish
Norsk/Norwegian
Česky/Czech
Polski/Polish
Magyar/Hungarian
-
EARTH
-
LIVE
-
NEUTRAL
Green/Yellow
Blue
(Neutral)
2
2
11
20
29
35
44
52
60
68
76
83
(Earth)
3A
Fuse
Brown
(Live)