Steinberg GROOVE AGENT 3 Mode D'emploi page 15

Now locate the Groove Agent 3 VSTi in the Synth Rack and select
"Enable the MIDI output" when inserting Groove Agent 3 into your
project. You will then see Groove Agent appear in your MIDI input
port drop-down selection. This will allow you to route the MIDI output
from Groove Agent 3 to any other MIDI track in a SONAR project.
Using Groove Agent 3 in an AU compatible application
For Logic Pro 7 proceed as follows:
1. Open the Track Mixer and choose the desired Instrument channel.
2. Click the I/O field and, in the pop-up menu that appears, choose ei-
ther "Multi-Channel" or "Stereo".
3. In the sub-menu the appears. select All Instruments and then Groove
Agent 3.
4. Groove Agent 3 is now loaded as an AU instrument.
Groove Agent 3 stand-alone and ReWire
Groove Agent 3 can be used as a stand-alone application, indepen-
dently of any host application. This makes it possible to use Groove
Agent in sequencer applications that do not support one of the pro-
vided plug-in formats of Groove Agent (i.e. VST, DXi, AU), but allow
for data exchange using ReWire.
ReWire2 is a special protocol for streaming audio and MIDI data be-
tween two computer applications. When using ReWire, the order in
which you launch and quit the two programs is very important, as the
first audio application launched will capture the sound card re-
sources.
Proceed as follows:
1. First, launch the sequencer application you wish to use (e.g. Ableton
Live, ProTools).
If your sequencer supports ReWire, it will provide a way to assign audio and MIDI
channels for the exchange of data. See the documentation of your sequencer applica-
tion for details.
Groove Agent 3
14 English