Setting Up The Instrument - Steinberg GROOVE AGENT 3 Mode D'emploi

Setting up the instrument

Groove Agent 3 as a VST Instrument in Cubase
This section describes how to set up Groove Agent 3 with Cubase as
your host application. However, the same procedure applies to most
host applications, and you should consult your host's documentation
if you need further help.
Make sure the host program has been correctly installed and set up to
work with your MIDI and audio hardware (e.g. MIDI keyboard and an
audio card).
To set up Groove Agent 3:
1. Open the VST Instruments window.
2. Click the "No Instruments" label and select Groove Agent 3 from the
pop-up menu.
3. Wait for a few seconds while Groove Agent 3 loads its default style
samples. The Groove Agent window opens automatically.
4. In the VST host application, select Groove Agent 3 as the output for a
MIDI track.
Groove Agent 3 as a DXi2 Instrument in Sonar
In SONAR you load Groove Agent 3 into the Synth Rack.
1. Open the Synth Rack and choose "Insert soft synth". You will then
need to scroll through the list and find Groove Agent 3.
2. You are provided with the option of inserting the default MIDI control
track as well as one or all of the audio outputs of Groove Agent 3.
MIDI Output in SONAR 5.2 or higher
Note that the DXi version of Groove Agent 3 does not support MIDI
output. If you desire this functionality, you will need to install the VST
version of Groove Agent 3. Having done so, you will need to run SO-
NAR's VST configuration wizard in order to locate and configure
Groove Agent 3.
Groove Agent 3
English 13