Configuration Using The Stop Button - Roco Z21 dual BOOSTER Manuel D'utilisation

Z21 Booster
®_
The booster track outputs are deactivated in configuration mode.
The changes are accepted immediately if the booster is on configuration mode.
To quit the configuration mode and return to the normal mode, enter the value 0 in the CV 10 or switch
the Z21 -Boosters off and on again.
®

Configuration using the STOP button

The booster can also be configured using the button.
Switch the booster to configuration mode for the first track output by pressing the STOP button for at
least 2 seconds until the status LED starts to flash green. Now release the button.
If you should have a dual booster and wish to configure the second track, press the STOP button for at
least 4 seconds until the status LED starts to flash white (i.e. the red, the green and the blue LEDs flash
at the same time).
After the STOP button has been released, the "Status" LED shows the currently selected configuration
option:
The track outputs of the booster are deactivated when it is in configuration mode.
Green indicates an "activated" status and red indicates a "deactivated" status. The selected configura-
tion option can be activated or deactivated by briefly pressing the button.
The setting is accepted after the button has been pushed again for a longer period of at least 2 seconds,
before the next configuration option is accessed. This is signalised by a rapid flashing of the LEDs. After
the last configuration option has been accepted, the configuration mode is quitted and the track output
remains deactivated. A final short pressing of the STOP button returns the booster to normal mode.
46
46
8010806920 neu.indd 46
flashes 1 x Option 1: RailCom
flashes 2 x Option 2: Auto-inversion
flashes 3 x Option 3: Short circuit forwarding to the control centre
flashes 4 x Option 4: DCC brake generator
flashes 5 x Option 5: Track voltage default values green=18 V, red=14 V
®
25.10.2018 13:04:45