Reset To Factory Default Settings; Status-Led - Roco Z21 dual BOOSTER Manuel D'utilisation

Z21 Booster
®_

Reset to factory default settings

Should it be necessary to reset all of the settings to the factory default settings, press the STOP button
until the status LED flashes violet (i.e. red + blue flash at the same time). This triggers a resetting to the
factory default settings and the track output is activated automatically.

Status-LED

In Operation:
Colour
Blue
Blue
Blue
Blue
48
48
8010806920 neu.indd 48
This track default value is always of relevance if the control centre set-
tings cannot be automatically detected via the B-Bus or the CDE of if
the "Auto Settings" (CAN) option is deactivated. Please also refer to
Chapter: Configuration and firmware update via CAN and Z21
nance tool.
Should a voltage default value other than 18 V or 14 V have already
been set using the maintenance tool or POM programming, then one
value of > 16 V is indicated by the colour green and one of > 16 V is
indicated by the colour red.
18 V is set as standard.
Status Meaning
on (light) Normal mode with CAN and activated auto-settings,
i.e. the settings (voltage and RailCom
ly accepted by the Z21
on, switch- Normal mode with CAN and deactivated auto-set-
es slowly tings, i.e. the settings (voltage and RailCom
between light automatically accepted by the Z21
and dark
The default values that are set in the booster are used.
on (dark) Normal mode with B-Bus, CDE or via CAN with a Z21
with an older firmware < V1.23 without ZCAN20 stack
(firmware update recommended).
The default values set in the booster are used.
flashing STOP, track voltage deactivated.
) are automatical-
®
via CAN.
®
) are NOT
®
via CAN.
®
mainte-
®
®
25.10.2018 13:04:45