Configuration Using Pom Write Commands - Roco Z21 dual BOOSTER Manuel D'utilisation

Z21 Booster
®_
With the Default Werte (default values) button, you can restore the factory default settings of the
Z21 -Boosters in the entry fields in the dialogue window.
®
With Lesen (read), the settings can be read out of the Z21
With Schreiben (write), the values in the entry fields are transferred to the Z21
With FW Update, the firmware in the Z21
concerning the progress of the update respectively is shown in the Update Info field.
In the interest of further development, we reserve the right to make improvements and extensions with
regard to the settings.

Configuration using POM write commands

The Z21 -Boosters can also be configured using POM programming commands as long as it is config-
®
uration mode. Should the Z21
accept POM write commands. If the Z21
the configurations via POM.
The POM programming ("Programming on Main" = programming on the main track) normally serves to
enable the programming of the locomotive decoder to be carried out at the main track. The Z21
can respond to these POM programming commands by way of exception when it is in configuration mode
– and only then – as long as these are directed at the "locomotive address" 9806. Should you coinci-
dentally have a locomotive with this address, please remove it from the track beforehand if necessary.
Switch the booster to configuration mode by pressing the STOP button for at least 2 seconds until the
status LED starts to flash green or red. Now release the button.
You can now change the settings by entering the following CV variables in the pseudo "locomotive ad-
dress" 9806 via POM using a WLAN-MULTIMAUS
CV-Nr. Meaning
7 Firmware Major Version
8 Manufacturer code;
CV 8=8  Restore works settings
10 CV 10=0  Quit configuration mode and return to
normal mode
65 Firmware Minor Version
44
44
8010806920 neu.indd 44
-Boosters can be updated. The target version or information
®
-Boosters be connected via the B-Bus or the CDE port, it is only able to
®
-Boosters is connected via the CAN-Bus, it is possible to read
®
, MULTIMAUS
®
-Boosters and displayed.
®
-Boosters.
®
or another input device of your choice:
®
r / w (CAN)
read only
read / write
only / write
read only
-Boosters
®
Value
161
0
25.10.2018 13:04:45