Responsibility; General - DAB e.sybox Instructions Pour L'installation Et L'entretien

GB
ENGLISH

RESPONSIBILITY

The Manufacturer does not vouch for correct operation of
the electropumps or answer for any damage that they may
cause if they have been tampered with, modified and/or run
outside the recommended work range or in contrast with
other indications given in this manual.
The Manufacturer declines all responsibility for possible er-
rors in this instructions manual, if due to misprints or errors
in copying. The Manufacturer reserves the right to make any
modifications to products that it may consider necessary
or useful, without affecting their essential characteristics.

1- GENERAL

The product is an integrated system composed mainly of a self-priming
multi-stage centrifugal electropump, an electronic circuit that controls it
and an expansion vessel.
Applications
Water systems supply and pressure boosting domestic use or industrial
use.
On the outside the product appears as a parallelepiped that presents 6
faces as shown in Fig.1.
A A B B
61
E E
C D
F F
Figure 1
Face A: a door allows access to the Technical Compartment. The door can
be removed by inserting 2 fingers in the rubber grips, squeezing and rotat-
ing the door around the hinges on the side opposite the grips (see Fig.2).
To put the door back in place, insert the hinges in their slots and close the
door until it clicks.
Figure 2
Inside the technical compartment you can access (see Fig.3):
1. Valve of the expansion vessel;
2. Technical data plate;
3. Rapid Guide;
4. Motor shaft;
5. Accessory tool;
6. Filling cap (only for vertical
configuration)
Face B: a removable screw cap gives access to the non return valve (see
par. 10.3). Remove it only in the case of maintenance by skilled personnel.
Face C: the 4 brass threads form the seat for the 4 support feet in the case
of vertical installation. The two 1" screw caps can be removed to make the
connections towards the system, depending on the installation configura-
tion you want to adopt. If applicable, connect to the connection marked
"IN" the system from which you want to draw water (well, cistern,...) and
connect the delivery system to the connection marked "OUT". There is also
a ventilation grid.
Face D: removing the 1" cap allows access to a second delivery connec-
tion which can be used at the same time or alternatively to the one marked
Figure 3