Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INDEX
1.
GENERAL
2.
2.1
2.2
2.3
3.
4.
5.
6.
7.
8.
8.1.
9.
10.
11.
12.
13.
14.
ELECTRONIC CONTROL UNIT
15.
TABLE WITH KEY OF ALARMS DISPLAYED IN THE ELECTRIC CONTROL UNIT
"PUMPS CONTROLLER"
16.
TABLE OF PARAMETERS TO BE SET IN THE "PUMPS CONTROLLER" ELECTRONIC
CONTROL UNIT ONLY FOR DAB SERVICE
17.
TABLE OF PARAMETERS TO BE SET IN THE "PUMPS CONTROLLER" ELECTRONIC
CONTROL UNIT ONLY FOR DAB EXTENDED PROGRAMMING
18.
EXAMPLE OF CALIBRATING SETPOINT PRESSURE
19.
1.
GENERAL
Read this documentation carefully before installation.
Installation and operation must comply with the local safety regulations in force in the country in which
the product is installed. Everything must be done in a workmanlike manner.
Failure to respect the safety regulations not only causes risk to personal safety and damage to the
equipment, but invalidates every right to assistance under guarantee.
2.
WARNINGS
2.1
Skilled personnel
It is advisable that installation be carried out by competent, skilled personnel in possession of the
technical qualifications required by the specific legislation in force. The term skilled personnel
means persons whose training, experience and instruction, as well as their knowledge of the respective
standards and requirements for accident prevention and working conditions, have been approved by the
person in charge of plant safety, authorizing them to perform all the necessary activities, during which
they are able to recognize and avoid all dangers. (Definition for technical personnel IEC 60634)
2.2
Safety
Use is allowed only if the electric system is in possession of safety precautions in accordance with the regulations in
force in the country where the product is installed (for Italy CEI 64/2).
Ensure that the control panel has not suffered any damage during transport or storage. In particular, check that the
outer casing is unbroken and in excellent conditions and that all the internal parts of the panel (components, leads,
etc.) are completely free from traces of humidity, oxide or dirt: if needed, clean accurately and check the efficiency
of all the components in the panel; if necessary, replace any parts that are not perfectly efficient. It is indispensable
to check that all the panel leads are correctly tightened in the respective clamps.
In the event of a long storage period (or when any component has been replaced), it is advisable to perform on the
panel all the checks indicated by standards EN 60204-1.
2.3
Responsibility
The Manufacturer does not vouch for correct operation of the panel or for any damage that it may
cause if it has been tampered with, modified and/or run outside the recommended work range or in
contrast with other indications given in this manual.
The Manufacturer declines all responsibility for possible errors in this instructions manual, if due
to misprints or errors in copying. The Manufacturer reserves the right to make any modifications
to products that it may consider necessary or useful, without affecting their essential characteristics
ENGLISH
35
page
35
35
35
35
35
36
36
36
36
36
36
37
39
39
39
39
40
42
43
44
46
50
51
171
Publicité
Chapitres
Table des Matières
