Safety Mode Operation - DAB e.sybox Instructions Pour L'installation Et L'entretien

No control
unit asso-
ciated
Communication with control
e.sybox
setting
Function
activated
(by means
of input or
In=0 Input func- No action No action
tion disabled
No action System in
(2)
In =1, 2
Low water level stop status F1
indicated by
float switch
No action Activation of
(2)
in =3, 4
Pauxn auxiliary correspond-
ing auxiliary
setpoint
setpoint
No action System in
(2)
in =5, 6
Disable system stop status F3
No action System in
in (2) =7, 8
Disable system
stop status
+ fault and F3 + fault and
warning reset warning reset
No action
in =9 Fault and
Fault and warn- warning reset
ing reset
e.sybox response
Control unit associated
No commu-
nication with
unit
control unit,
Function not
or control
activated
unit error
(by means
of input or
Safety mode
menu) menu)
No action No action
No action System in
stop status
No action Activation of
lowest auxil-
iary setpoint
pressure set
No action System in
stop status
No action System in
stop status
No action No action
No action
(2)
in =10, 11, 12,
13 Kiwa function
(low input pres-
sure signal)
No action
PR=0
Remote pres-
sure sensor
disabled
No action
PR=1
Use of remote
pressure sensor
Tab.5 Triggering of safety mode
The activation of the function relating to this box + any other function in
(1)
safety mode triggers a system stop. In this case, the system displays the
highest priority stoppage cause.
(1)
The numbers separated by commas indicate the possible setting values
(2)
for the function concerned
Instead, as regards the control unit, if there is a loss of communication it
lights relay 1 depending on the settings of O1 (see tab 20), considering the
lack of communication an error condition.
(1)
(1)
System in No action System in
stop status F4
stop status
No action No action No action
No action Remote set-
Setpoint
on remote point ignored
sensor
GB
ENGLISH
(1)
74