Fitting The Brushes; Machine Setup; Fitting The Floor-Tool - Numatic TTB 6055/100T Mode D'emploi

!

Fitting the Brushes

9
550 mm Brush or a 500 Pad on the TTB 6055/100T.
Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
Slide the brush / pad under the brush deck (Fig.9).
Fit the brush / pad onto the Nulock drive chuck, twist to lock the brush / pad in place (Fig.10).
Safety gloves are recommended for the changing of used brushes.

Fitting the Floor-tool

The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor-tool gets snagged, whilst in transit.
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
12
Machine Set-Up
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Fit the floor-tool and retain using the detent pin (Fig.11).
Push waste collection pipe onto the
floor-tool; ensure a tight fit (Fig.12).
Raise the floor-tool for transit or lower for
cleaning operation using the lifting handle
fitted to the back of the machine (Fig.13).
10
Note:
11
22
13
!