Setting The Cleaning Controls; Turning The Machine On; Setting The Water Flow Rate; Setting The Speed - Numatic TTB 6055/100T Mode D'emploi

Turning the Machine On

Setting the Water Flow Rate

Setting the Speed

Hi - Lo Setting

Setting the cleaning controls

0.5L/Min, 1L/Min, 2L/Min, 3L/Min
Set desired traction Speed as required, depending on
floor type and level of soiling.
Middle speed is the optimum cleaning speed.
Once the Max speed has been set using the knob on
the control panel, fine adjustments can be made using
the variable control speed trigger.
The TTB 6055T has been fitted with a Hi - Lo mode, this reduces the noise produced by the
vacuum motor.
To operate the Hi - Lo mode start the machine in the normal way.
When the machine is running normally the Hi Lo light will be illuminated blue, this means the
Vacuum motor is running at 100%
With the machine running press the Hi Lo button once the Vacuum motor will reduce speed to
75% of capacity and the Hi lo light will not illuminate.
Insert the key, turn the main control on / off key
to position '1'.
The battery charge level meter will illuminate for
5 seconds.
Set Water Flow Rate as required, depending on
floor type and level of soiling
30