SRAM MTB Manuel De L'utilisateur page 113

4 Align the caliper body halves then use a T25 TORX
each body bolt into the caliper two full turns.
Install the heat shield into the tabs, and make sure the heat shield is
pushed firmly flush against the caliper.
If the heat shield is not installed so that it is pushed against the caliper
wall, then it could interfere with brake performance.
5 Tighten each body bolt.
6
Remove the o-rings from the banjo bolt and banjo fitting.
Apply a small amount of SRAM® High-Performance DOT 5.1 fluid to the
new o-rings and install them.
®
wrench to thread
NOT ICE
T25
T25 TORX
SRAM DOT 5.1 fluid
20 mm or 15 mm Thru Axle
9.8 - 11.8 N·m (87 - 104 in-lb)
20 mm or 15 mm Thru Axle
Caliper Piston Installation 15