Table des Matières
Publicité
T r o u b l e s h o o t i n g
D i s c B r a k e P a d A d v a n c e m e n t P r o c e d u r e
If your brakes have excessive brake lever throw, it may be a result of the pistons sticking in the caliper. Before bleeding the system, you can try to
loosen the sticky piston by performing the following steps:
Clamp the bicycle into a bicycle work stand and remove the wheel
1
according to the wheel manufacturer's instructions.
Squeeze the brake lever several times until the brake pads nearly
2
contact one another.
Insert the pad spacer tool between the brake pads to spread the pads
3
to the full width of the clip.
Remove the pad spacer tool.
4
Pad spacer tool
Troubleshooting
7
Publicité
Table des Matières
Dépannage
