Buzzer Settings - Sony HSR-X216 Mode D'emploi

3
Highlight the item to be set, then turn Shuttle dial
clockwise.
The current setting flashes.
4
Turn the Jog dial to change the ON/OFF setting,
then turn the Shuttle dial clockwise to register your
setting.
Repeat steps 3 and 4 for each item to be set.
When the settings are completed
Press the EXIT/OSD button to exit the menu.
Setting the titles
You can register titles for each camera to indicate the
camera location (ex. ROOM 1, ROOM 2 ) etc.
Characters that can be used in titles
Alphabetics: A to Z
Numerics: 0 to 9
Symbols: - (hyphen), : (colon), . (period),
/ (slash), * (asterisk), space
1
Move the cursor to TITLE SET, then turn the
Shuttle dial clockwise.
A camera picture is displayed full-screen, and a
figure line for title setting is superimposed.
(To set a title for the camera picture displayed,
proceed to step 3.)
2
Select the camera picture to be set using the
INPUT SELECTOR buttons.
3
Select a character at the cursor using the Jog dial,
then turn the Shuttle dial clockwise.
The cursor moves to the next position.
4
Select the desired characters and figures for the
title (max. 10 characters) in the same manner.
5
Repeat steps 2 to 4 for each camera.
When the settings are completed
Press the EXIT/OSD button to exit the menu.

Buzzer Settings

You may independently turn on/off the buzzers for
warning.
Use the submenu 2. BUZZER SET of the main menu
3. GENERAL SET.
1
Select 3. GENERAL SET from the main menu.
2
Select 2. BUZZER SET from the submenu.
The BUZZER SET display appears.
<BUZZER SET>
ALARM : ON
DISK FULL : ON
DISK ERROR : ON
LOCK WARNING : ON
KEY IN : OFF
NON REC : OFF
ALARM: Buzzer that sounds when an alarm is
generated
DISK FULL: Buzzer that sounds when the
remaining of the normal recording or alarm
recording area drops below the specified value.
DISK ERROR: Buzzer that sounds when an error
is generated for the hard disk
LOCK WARNING: Buzzer that sounds when an
operation key is pressed with the security lock
active.
KEY IN: Buzzer that sounds when an operation
key is pressed
NON REC: Buzzer that sounds when recording is
interrupted
3
Highlight the buzzer to be set and turn Shuttle dial
clockwise.
The current setting flashes.
4
Turn the Jog dial to change the ON/OFF setting
and turn the Shuttle dial clockwise to register your
setting.
Repeat steps 3 and 4 for each buzzer to be set.
5
When the settings are completed, press the EXIT/
OSD button to exit the menu.
65
(GB)