Sony HSR-X216 Mode D'emploi page 13

q; MONITOR 1 connector (BNC type)
To output a video signal to a main monitor. Connect
to the video input of the monitor.
qa MONITOR 2 connector (BNC type)
To output a video signal to a sub monitor. Connect to
the video input of the monitor.
qs RS-485 connectors (A/B)
Connect a RS-485 serial control bus with an RJ-11
cable. Use these connectors for connecting devices
controlled by the controller or the same bus.
For details, see "Connections for Remote Control and
Associated Settings" on page 58(GB).
Notes
• Do not connect a phone line to these connectors.
• Two RS-485 control ports can be connected to these
connectors.
qd RS-232C connector (D-sub 9-pin)
An external controller, such as a PC, can be connected.
qf All Reset button
For CPU reset
qg RS485 TERMINATE switch
For RS-485 termination. When connecting multiple
units in series via the RS485 terminals, set this switch
of the last unit to ON.
qh Control terminals
For input and output of various control signals. The C
terminals are for ground.
ALARM
C R1 R2 ALL OUT RESET
R1/R2 terminals (resistor-alley system)
For remote control.
For the connections, see "Connections for Remote Control
and Associated Settings" on page 58(GB).
NON REC
WARNING
ALARM
FULL C
FULL
ALL terminal (5V DC/5.7 kΩ)
You may adjust the built-in clock of other connected
devices to the clock of this unit.
ALARM terminals
For signals that can be triggered for alarm recording
OUT: Sensor alarm signal output (5V DC/5.7 kΩ).
The output level drops to 0 V when the built-in
activity detection sensor operates or an external
alarm is detected.
RESET: Alarm reset input (normally-open contact)
NON REC terminal (5V DC/5.7 kΩ)
The output level drops to 0 V if recording is
interrupted.
WARNING terminal (5V DC/5.7 kΩ)
The output level drops to 0 V if any problem occurs
with the HDD or fan.
FULL terminal (5V DC/5.7 kΩ)
The output level drops to 0 V if the remaining capacity
of the normal recording area of the built-in hard disk
drops below the specified value (default: 1%).
ALARM FULL terminal (5V DC/5.7 kΩ)
The output level drops to 0 V if the remaining capacity
of the alarm recording area of the built-in hard disk
drops below the specified value (default: 1%).
13
(GB)