Procedure Of Normal Recording; Recording Time - Sony HSR-X216 Mode D'emploi

Normal Recording
Supplementary information regarding the

recording time

The recording times listed in the tables on pages
33(GB) and 34(GB) and show the values with the
following conditions:
• The hard disk capacity of this recorder is 320 GB:
If you install additional hard disk to double the
capacity, the recording times will also become
doubled, and with the capacity increased fourfold, the
recording times will also increase fourfold.
• Of the capacity of the disk, 1% is used as the archive
area and the remaining 99% is used as normal
recording area.
• If multiple cameras are connected, they will share the
recording areas. For example, when you set the
recording rate to 1 FPS with 9 camera inputs, one
input is recorded at 0.111 FPS (each 9 seconds).
Note
The size of a picture file may vary, as pictures are
recorded with JPEG compression. The recording
times, therefore, may not always match the values
shown in the tables.
32
(GB)

Procedure of Normal Recording

MULTI QUAD OPTION MONITOR 2
POWER
1 2 3 4 5
ALARM
ALARM FULL
9 10 11 12 13
FULL
DIGITAL SURVEILLANCE RECORDER HSR-X216P
FULL indicator
To start recording
Press the z REC button.
The indicator on the z REC button lights, and
recording begins.
Recording is made with the specified picture quality
and at the specified recording cycle in the normal
recording area.
When you set AUDIO RECORDING to ON and audio
recording is valid with the specified recording cycle,
audio is recorded with video.
Note
When timer recording has been set (the indicator on
the TIMER button lit), recording cannot be started
with the z REC button. First press the TIMER button
to cancel timer recording.
When the normal recording area becomes full
If overwriting of the normal recording area has been
set to OFF, a warning message will appear on the
monitor screen when the remaining capacity drops to
the specified value (1% with the default). At the same
time, the FULL indicator flashes and a warning signal
is output from the FULL terminal on the rear panel.
The overwriting ON/OFF setting and the value of the
remaining for warning can be changed with the
submenu 2. RECORDING CONDITIONS SET of the
main menu 2. RECORD SET.
For details, see page 64(GB).
To stop recording
Press the REC STOP button.
-
l ALARM L
LOCK
ALARM RESET
PRE REVERSE PLAY
6 7 8
S PAUSE s STOP G PLAY
INPUT
SELECTOR
14 15 16
REC
TIMER a REC
STOP
REC STOP button
z REC button
and indicator