Safety Devices - John Bean T 8058 Manuel D'utilisation

2
3
9
10
14
16
1
4
5
7
8
6
12
11
15
1.3-1
Safety

1.3 Safety Devices

WARNING: DO NOT BYPASS ANY SAFETY
FEATURES.
This machine has several protectors to prevent
compression or crushing hazards.
List of safety devices:
Fig. 1.3-1
1. Turntable guard
2. arm guard
3. motor drive belt guard
4. safety lever
5. arm drop prevention lock valve
6. tool casing lock valve
7. tool casing cylinder guard
8. tool drive upper cover
9. tool drive closing plates
10. carriage movement front guard
11. carriage movement rear guard
12. pedal guard
13. Mushroom-head emergency stop push-button,
pedal unit switch off
14. Hydraulic Control Unit start push-button
15.Main Switch
- There is a micro-switch protection under the
chuck arm to prevent compression.
- The rotation speed of the chuck has been
limited to a maximum of 8 rpm to reduce dragging or
entrapping hazards. There is an emergency button
on the portable control unit.
13
- All machine movements, except turntable
rotation and tool lifting, are automatically inhibited if
the tool is not in the operating position (fully low-
ered), or in the home position (fully lifted).
DUE TO INEVITABILE RESIDUAL RISKS, ALWAYS
OPERATE WITH ADEGUATE CAUTION AND
I N C O M P L I A N C E W I T H A L L T H E S A F E T Y
INSTRUCTIONS LISTED HERE.
Operator's Manual
John Bean T 8058